Troubleshooting
Start with the symptom you can observe. Apply one change at a time, then retry the code you use for your device.
| Symptom | Check | Fix |
|---|---|---|
| No signal gets through at all | Is OE wired to a controller pin that drives it low? A low OE switches every output into the 3-state mode. | Leave OE unconnected (the board pulls it up to VCCL), or drive it high. |
| Nothing works, or the levels look wrong | Which supply is on VCCL? VCCL must never be higher than VCCH. | Put the lower supply (1.65 V to 3.6 V) on VCCL and the higher one (2.3 V to 5 V) on VCCH. |
| The device never answers | Is each device on the right side? A1 to A4 follow VCCL and B1 to B4 follow VCCH. | Move the lower-voltage device to the A pins and the higher-voltage device to the B pins. |
| Communication is erratic | Are both systems' grounds connected to the board? | Connect each system's GND to the GND pin on its side. The two pins are joined on the board. |
| A signal arrives on the wrong line | A1 pairs only with B1, A2 with B2, and so on. | Check that each signal uses the same channel number on both sides. |
Still blocked?
Ask on the community forum. Include the following so someone can reproduce it:
- product name and SKU: Logic Level Converter I2C TXS0104 Breakout,
333016 - both boards you are connecting, with their supply voltages
- complete error text or unexpected output
- which pins you used on each side, and whether
OEis connected - a clear photo of the wiring