Learn
Each example page explains one library example for this board and every function it uses.
Arduino
ArduinoRead the NO concentration with ArduinoStart the board at address 0x30 and print the NO concentration in ppm.ArduinoAverage several readings with ArduinoAverage five readings, three seconds apart, and print the result in ppm.ArduinoCalibrate the zero point with ArduinoAdd a voltage offset so the reading sits at 0 in clean air.ArduinoStart a sensor at another addressPass your own address and LMPEN pin to the constructor.ArduinoUse your own front-end settings with ArduinoBuild your own sensorType preset for a cell.ArduinoThe singleSensor example with ArduinoThe example creates one sensor at the library's default address, 0x49, and prints a reading in ppm.ArduinoRead two sensors on one bus with ArduinoRead two boards at two addresses on one I2C bus.
MicroPython
MicroPythonRead the NO concentration with MicroPythonStart the board at address 0x30 and print the NO concentration in ppm.MicroPythonAverage several readingsAverage five readings, three seconds apart, and print the result in ppb.MicroPythonCalibrate the zero pointAdd a voltage offset so the reading is just barely 0 in clean air.MicroPythonUse your own front-end settingsBuild your own preset with SensorConfig and read in ppb.MicroPythonThe singleSensor example with MicroPythonThe example creates one sensor at the module's default address, 0x49, and prints a reading in ppb.MicroPythonRead two sensors on one busRead two boards at two addresses on one I2C bus.