Quick Start
Get NULA Node RP2040 running in the Arduino IDE: install the RP2040 board package, select the board, and upload a short sketch that prints a greeting over USB.
- Arduino
1. Install the platform
Download and install the Arduino IDE from arduino.cc. On Windows, use the plain Windows installer or the Windows ZIP from arduino.cc, not the Windows Store version, and allow it to install any device drivers it suggests. Otherwise the board may not be detected.
2. Install the board definitions
-
Open the Arduino IDE and go to File → Preferences.
-
In the dialog that pops up, enter this URL in the Additional Boards Manager URLs field, then click OK to close the dialog:
https://github.com/earlephilhower/arduino-pico/releases/download/global/package_rp2040_index.json -
Go to Tools → Boards → Board Manager in the IDE.
-
Type
picoin the search box and select Add.
The board menu entry in the next step is the one in arduino-pico version 6.3.0.
3. Select the board
Select the board:
Tools → Board → Raspberry Pi RP2040/RP2350 Boards → Soldered Electronics NULA Node
4. Upload your first program
This sketch prints a greeting once a second, which is the quickest way to see that the upload worked.
void setup()
{
Serial.begin(115200);
}
void loop()
{
Serial.println("Hello from Soldered NULA Node RP2040!");
delay(1000);
}
5. What to expect
For the first upload, hold the BOOT button down while you plug the board into your computer with the USB-C cable, then click Upload. The sketch transfers and starts to run.
After the first upload, select the board's serial port in Tools → Port
once. The setting stays, and later uploads should not need the button. Open
Tools → Serial Monitor and set it to 115200 baud.
Hello from Soldered NULA Node RP2040!
Hello from Soldered NULA Node RP2040!
Hello from Soldered NULA Node RP2040!
6. Troubleshooting
If the board is not detected or the upload fails, continue with Troubleshooting.