Soldered Electrochemical NO Gas Sensor Breakout (Qwiic)
This board measures nitric oxide (NO) from 0 to 250 ppm with an SGX-4NO-250 electrochemical cell. An LMP91000 analog front end biases the cell and turns its current into a voltage, a 16-bit ADS1115 ADC converts that voltage, and an ATtiny404 talks to both chips for you, so your microcontroller sees one I2C device, at its default address, 0x30.
This documentation is for
ProductSoldered Electrochemical NO Gas Sensor Breakout (Qwiic)Nitric oxide sensor board with an SGX-4NO-250 cell for 0 to 250 ppm, read over Qwiic (I2C).ShopBuy it on our shopPrice, stock and every variant of this product in the Soldered shop.Open the shop pageAt a glance
InterfaceI2C over Qwiic, address 0x30 (0x30 to 0x37 by switch)
Main ICLMP91000 analog front end, ADS1115 16-bit ADC, ATtiny404 bridge
Gas cellSGX-4NO-250, nitric oxide (NO)
Range0 to 250 ppm, 0.5 ppm typical resolution (electronics dependent), T90 under 40 s
Voltage3.3 V only, no regulator
Connectors2 x Qwiic, 2.54 mm headers
Dimensions38 x 38 mm
Environments-30 to 50 °C, 15 to 90% RH
What's in the box
| Qty | Item | Notes |
|---|---|---|
| 1 | Soldered Electrochemical NO Gas Sensor Breakout (Qwiic) (main product) | SKU 333327 |
| 1 | Header pins (unsoldered) | For the 2.54 mm header pads. The board itself is not breadboard compatible. |

