Soldered Electrochemical NO2 Gas Sensor Breakout (Qwiic)
This board measures nitrogen dioxide (NO2) from 0 to 30 ppm with an SGX-4NO2 electrochemical cell. An LMP91000 analog front end biases the cell and turns its current into a voltage, a 16-bit ADS1115 ADC converts it, and an ATtiny404 talks to both chips for you, so your microcontroller sees a single I2C device. Plug it in with either Qwiic connector, and give each board its own address from 0x30 to 0x37 to put up to eight on one bus.
This documentation is for
ProductSoldered Electrochemical NO2 Gas Sensor Breakout (Qwiic)NO2 sensor board with an SGX-4NO2 cell, 0 to 30 ppm, read over Qwiic.ShopBuy it on our shopPrice, stock and every variant of this product in the Soldered shop.Open the shop pageAt a glance
InterfaceI2C over Qwiic, address 0x30 (0x30 to 0x37 by switch)
Main ICLMP91000 analog front end, ADS1115 16-bit ADC, ATtiny404 bridge
GasNitrogen dioxide (NO2), SGX-4NO2 electrochemical cell
Range0 to 30 ppm, 0.1 ppm typical resolution (depends on the electronics), T90 under 30 s
Voltage3.3 V only, no regulator
Connectors2x Qwiic, 2.54 mm headers
Dimensions38 x 38 mm
Environments-30 to 50 °C, 15 to 90% RH
What's in the box
| Qty | Item | Notes |
|---|---|---|
| 1 | Soldered Electrochemical NO2 Gas Sensor Breakout (Qwiic) (main product) | SKU 333326 |
| 1 | Header pins (unsoldered) | Solder them on to connect the board with jumper wires instead of Qwiic, as in the Quick Start |

